Building Childrens Furniture
In some cases plywood is more expensive than solid wood, but this is not usually the case. In fact, in the case of fine hardwood plywoods of 3/4-inch thickness, the price is usually less.
In any event, the home hobbyist usually finds that money-saving is not the important factor when he selects material for his project, since materials seldom exceed one-third of the value of the average cabinet or piece of furniture.
In almost all of his furniture projects, Bill Baker gears his instructions toward the use of plywood rather than solid wood, not only because of the factors of wood strength and outdoor durability, but also because of the simplicity in cutting out necessary pieces.
There is usually little waste, there are less operations required for the home hobbyist, and plywood is available in a very wide range of beautiful hardwoods. New techniques for edge treatment, such as Wood-Trim in matching veneers, also add simplicity to the job.
Duraply is plywood with a special over-lay surface; it is non-porous and is, therefore, easy and economical to paint. When finished, Duraply has a handsome appearance.
Nakora is the most handsome of economical plywoods for indoor furniture, particularly for modern furniture. Birch plywood is one of the strongest hardwood plywoods available and it is especially suited for colonial furniture. When it is stained—which it takes nicely without filling—it can be made to resemble most any wood finish. Since it isn't porous, it lends itself very well to painting and is especially good for children's furniture.
Furniture
Where Antiques Originate And How You Can Find Them
Building Childrens Furniture - Lumber
Furniture
... These are made of 2-inch thick hardwood and function very efficiently by means of small wooden wedges forced under them. To use the wedge clamp, slip it over the freshly glued and joined pieces, then force a pair of small wooden wedges under the upper jaw, driving the wedges in from opposite sides until ...
... is first to make a full-scale layout sketch of the piece on a large sheet of paper tacked on a piece of plywood. Such a drawing will graphically reveal in full size all angles, bevels, miters, curves, assembly points, and true measurements. In fact, full-size patterns can be cut from your layout on heavy ...
... so-called antique or Barbizon-type frames by giving them an all-over neutral effect with only touches of color or gilt as accents. The beginner in frame-making is often confused as to the choice of molding or finish for a particular picture and therefore falls back on the practice of copying a frame or ...
... same limits of the saw cut. Next, mark two short lines across the top of the wood directly over the points where the groove or rabbet underneath is to begin and end. Then, without turning on the saw, lay the wood over the blade and flush against the fence, back it up until the for-ward line on the wood ...
Building Childrens Furniture - Lumber
... get from the lumberyard and the nominal size that you order. However, plywood is sold in the exact dimensions as offered. Board lumber nominally 1 inch thick will actually measure from 3/4 to 7/8 inch (usually 13/16 inch). And its actual width will be 3/8 inch less than its nominal width, in pieces between ...